Notifier Weatherproof Manual Call Point Break Glass Unit With Isolator M700WCP-R/I/SG
- Manufacturer : Notifier by Honeywell
- Part Number : M700WCP-R/I/SG / W5A-RP02SG-N026-01
- Weatherproof Addressable Call Point
- IP67 Rated
- Integral Isolator
- Supplied With Test / Reset Key
Notifier Weatherproof Manual Call Point Break Glass Unit With Isolator
KEY FEATURES OF THE NOTIFIER MANUAL CALL POINT BREAK GLASS:
Unique 'plug and play' installation concept
Resettable plastic element option available (not included)
Notifier Analogue Addressable Protocol Communications
Fully compliant with EN54 Part 11
This Notifier Weatherproof Manual Call Point Break Glass Unit M700WCP-R/I/SG is specifically designed to be used on Notifier Protocol Fire Alarm Control Panels. The unit is designed to give a manual signal to the Notifier Fire Alarm Control panel which will operate the fire alarm system. This unit is IP67 rated.
This unit features an integral loop isolator built into the device.
These units are based on the industry standard KAC manual call point. They have been designed specifically to give installation efficiency, flexibility and compliance with the latest standards.
The Notifier Manal Call Point Break Glass M700WCP-R/I/SG features an Integral LED. This LED will illuminate once the break glass unit has been operated. This feature allows easy identification as to which Notifier Manual Call Point Break Glass has been operated.
The Notifier Manual Call Point Break Glass Unit features a unique 'plug and play' concept that is designed specifically to reduce installation time by using a terminal block which can be wired during the initial installation cabling with a link to provide continuity for testing. During the commissioning phase, the links are removed and the terminal block is simply inserted into the connector at the back of the unit. No re-termination is required.
The Notifier Manual Call Point Break Glass M700WCP-R/I/SG uses one of 99 possible addresses which is simply 'dialled in' using the two rotary decade switches on the rear of the unit.
A specialist test key may be inserted into the bottom of the unit to lower the glass and release the micro-switch and thus a full functional test is achieved.
Please Note : This product is for purchase as a spare / replacement part for existing Notifier systems. Any extensions to existing systems or brand new systems MUST be commissioned by a Notifier ESD engineer in order to maintain the validity of the manufacturers warranty on the equipment. Please contact us for details on commissioning services.
Write Your Own Review